A direct toner for warmtone papers with a high content of chloride silver. Neutral- and coldtone emulsions can be toned indirectly (after bleaching).
The concentrated bleacher can be diluted between 1+10 and 1+50. If you only want to tone the highlights, weaker dilutions allow you higher control over the toning process.
To achieve clear image whites it is essential to carefully fix the print!
When toning indirectly, rinse the print thoroughly before bleaching. If you use your working solution only for direct toning, rinsing for 5 minutes after an alkaline fixer and for 10 minutes after an acidic fixer is sufficient.
To achieve a brown to red-brown image tone, use a toner dilution of between 1+10 and 1+50.
When toning warmtone paper (direct toning) the first thing that happens is an increase in maximum black. The shadows turn colder. In a dilution of 1+30 the highlights start shifting to warmer hues after around 30 seconds. Later in progress this hue turns towards red-brown or yellow-brown. Simultaneously the shadows become warmer. If you want intensive red-yellow highlights, you can bleach them a little bit before you start toning. Even if your bleacher is highly diluted, times between 15 and 30 seconds can already be sufficient.
To increase maximum black, you should use a strong working solution (1+10 to 1+15) and tone for only a short time. You will also get a colder image tone. To protect the image silver from environmental stresses, toner dilutions of between 1+100 and 1+200 and toning times of 3 to 6 minutes are sufficient.
Working solutions of up to 1+30 can be stored for a couple of weeks. Discard very highly diluted working solutions after use.
When you achieved the desired tone rinse the print in running water. The toner contains sodium-sulphur. Ensure sufficient ventilation at your working space.
100ml toner stock solution
100ml bleach stock solution
|Verpakking||1 x Moersch MT2 Carbon Toner (100ml), 1 x Moersch Bleacher (100ml)|
Geen klantenbeoordelingen op dit moment.